BUIDING MACH 3 CONTROL CENTER

February 01, 2013

BUIDING MACH 3 CONTROL CENTER

InterMAC CNC Milling Stone, the stock mainboard used float-disk to strore product’s CNC file that was difficult to change file and processing, small capacity and lots of setup steps before running.

After a long time used, the owner decided change mainboard using Mach3 on Computer that will be easy to input CNC file, changing, setup, managerment and running...............

 Z- axis

 Water cooler Tool

 X, Y, Z axis ServoPacks

 Inverter F4 reconnet cable with new mainboard

 Reconnect Contactor and Relay that changes state of water cooler, air pumps, startup, hold product,……...

 The new mainboard connect Computer through LPT cable

 LED states

 Mainboard and Extention Card

 FullView

 FirstView Looking

 Stock Input/Output FeildBUS card

 The new Input/Output ModBUS Mach 3 card

‘Hello !!!’